Yamaha TX5n - Manual (Page 35)

TX6n/5n/4n Reference Manual 35
Panel Operations
■ Oscillator Mix
This is a mono-channel oscillator. It generates a sine wave, pink noise, or burst noise. This can also mix the audio input signal
and oscillator signal.
■ X-Over Input Level (Speaker Processor)
This adjusts the input level to the crossover in a range of -
∞ – +10 dB.
■ X-Over Polarity (Speaker Processor)
This specifies the phase reversal of the input signal to the crossover.
Parameter name Range Explanation
PGM To SP ON/OFF Switches on/off the input from the Input Delay to the mix point before
the Speaker Processor.
Osc To SP ON/OFF Switches on/off the input from the oscillator to the mix point before the
Speaker Processor.
Osc On ON/OFF Turns the oscillator on/off.
Osc Level -
∞
–0.00 dB Specifies the output signal level.
Wave Form SINE100 Hz,
SINE1 kHz,
SINE10 kHz,
PINK, BURST, Vari
Selects the waveform that will be generated. If you select SINE (sine
wave), you can also select a frequency. If you want to freely specify the
frequency of a sine wave, select Vari.
Vari Freq 20.0 Hz–20.0 kHz If you selected Vari as the Wave Form, this specifies the frequency of
the sine wave that will be generated.