Xantrex Technology FREEDOM HF 1800 - Manual (Page 25)

975-0390-01-01 11
Freedom Inverter/Charger Configuration
Adjusting Feature Settings
The Power and Select buttons can be used to:
• change the charging current setting,
• change the inverter mode setting,
• disable or enable the audible alarm,
• change the shutdown setting, and
• return to factory default settings.
To cycle through the various feature settings:
1. Press and hold the Inverter Power button for five seconds to enter the
feature settings mode.
2. Press the Inverter Power button to toggle between the following
information:
To change the charger’s charging current setting:
By default the charging current is set to  for Freedom HF 1000,  for
Freedom HF 1055, and  for Freedom HF 1800 models.
1. Press and hold the Inverter Power button for five seconds.
The LED screen will flash “” intermittently.
2. Press the Select button once.
The LED screen will display the present charging current setting.
Example, “” for a 40 A setting.
3. Press the Select button again to change to the next setting.
The LED screen shows the next setting. Example, “” for a 2 A
setting.
4. Continue pressing the Select button to cycle through each of the
available settings – “”, “”, “”, and “”, such as in the case
of Freedom HF 1800, until you reach the desired setting.
5. Press and hold the Select button for five seconds to make the setting
permanent.
Figure 3 Display Panel
FREEDOM HF
Input Voltage (V)
Select
STATUS
Battery
Fault
Utility
Input Current (A)
Output Power (kW)
LED
screen
Status
LED light
Info and Settings LED lights
Inverter
Power
Setting LED Screen
Charging Current Setting 
Inverter Mode Setting 
Alarm Setting 
Shutdown Setting 
Factory Setting 
Freedom HF InvChg Owners Guide.book Page 11 Thursday, November 24, 2011 11:20 AM