Xantrex Technology FREEDOM HF 1800 - Manual (Page 49)

975-0390-01-01 35
Warning Messages
For error codes  to :
• the unit will stop inverting, and
• the display screen and the alarm will turn off after 30 seconds.
For error codes  and :
• the unit will stop charging, but
• the error code will still show on the display screen and the alarm will
remain on, and
• AC power will continue to pass through to the AC outlets.
For error code 
• the unit will stop charging and shut down, and
• the error code will show on the display screen briefly, and
• AC power will not pass through to the AC outlets.
To reset error codes  to :
1. Remove the AC input, and
2. Turn the unit OFF and then turn ON again using the Inverter Power
button on the display panel.
 Battery is bad or external DC
load is connected to the battery. AC shore power • Check the battery bank.
NOTE: The battery voltage did not rise above 5 volts DC after 1
minute or 10 volts DC after 15 minutes.
• Check that the external DC load current consumption is below the
charging current setting.
• Disconnect the DC load or increase the charger current setting.
Table 1 Error Codes Displayed on the Display Panel Screen
Error Code Condition Mode Action
Freedom HF InvChg Owners Guide.book Page 35 Thursday, November 24, 2011 11:20 AM