Yamaha Digital Sound Projector YSP-3050 - Manual (Page 78)

MANUAL SETUP
74
En
To achieve the best quality surround sound, you can use MANUAL SETUP to fine-tune the listening environment
parameters, as well as to make advanced settings for sound signals, sound beams, digital input, and the OSD. Change the
initial settings (indicated in bold under each parameter) to reflect the needs of your own listening environment.
y
• You can save the settings optimized by the AUTO SETUP procedure (see page 36). A set of settings optimized according to the
specific conditions of your listening environment can be recalled later depending on the varying conditions of your listening
environment (see page 37).
• Most of the parameters in SOUND MENU and BEAM MENU are automatically set when you run AUTO SETUP (see page 29). Use
SOUND MENU and BEAM MENU to make additional adjustments.
• BEAM MENU allows you to make settings for the surround sound effects normally available in the speaker settings menu.
• Make settings for the parameters in BEAM MENU first before making settings for the parameters in SOUND MENU, INPUT MENU,
and DISPLAY MENU.
SOUND MENU
Use to manually adjust the various parameters related to the sound output.
BEAM MENU
Use to manually adjust the various parameters related to the sound beam output.
INPUT MENU
Use to manually adjust the various parameters related to the audio and video input.
DISPLAY MENU
Use to manually adjust the various parameters related to the display.
MANUAL SETUP
Item Features Page
TONE CONTROL Adjusts the output level of high-frequency or low-frequency sound. 80
SUBWOOFER SET Adjusts the various subwoofer settings. 80
MUTE LEVEL Adjusts the muting level. 80
AUDIO DELAY Adjusts the audio delay. 81
ROOM EQ Adjusts the tonal quality of the listening room. 81
DD/DTS Dynamic Range Adjusts the dynamic range of Dolby Digital or DTS signals. 81
TruBass Selects the bass sound enhancer. 81
Item Features Page
SETTING PARAMETERS Adjusts the listening room and listening position settings. 76
BEAM ADJUSTMENT Adjusts the various sound beam settings. 77
IMAGE LOCATION Adjusts the sound position of the front left and right channels. 79
Item Features Page
INPUT ASSIGNMENT Assigns jacks according to the component to be used. 82
INPUT MODE Selects the initial input of the source. 82
INPUT TRIM Adjusts the input level of the source. 83
INPUT RENAME Renames the displayed input source. 83
HDMI SET Adjusts the various HDMI settings. 84
XM ANTENNA LEVEL Displays the current reception level of the XM Satellite Radio signal. 85
Item Features Page
F.DISPLAY SET Adjusts the front panel display settings. 86
OSD SET Adjusts the OSD settings. 86
UNIT SET Changes the display unit of measurement. 86