Yamaha Digital Sound Projector YSP-3050 - Manual (Page 97)

93
En
Adjusting the system parameters
AD
V
ANC
ED
OPERA
T
ION
English
7
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
The new setting will be activated when you turn on the
power of this unit next time.
y
When the demo mode is turned on, restart the unit, then press
ENTER while playing back sources to test the sound beam.
The sound beam being output shuttles between left and right.
Press ENTER again to stop shuttling.
FACTORY PRESET
You can reset all of the parameters of this unit to the factory presets. This procedure
completely resets ALL the parameters in SET MENU.
After performing the following procedure you must run AUTO SETUP again to match your surround
sound environment.
RESET, CANCEL
Parameter to be changed and front panel display Parameter settings
Note
F A C T O R Y P R E S E T
STANDBY/ON