Yamaha CLAVINOVA C L P - 3 8 0 - Manual (Page 104)

CLP-380 Owner’s Manual 104
Detailed Settings
Message List
The messages are listed in alphabetical order.
Message Meaning
• This message appears when data has failed to be written or loaded to the Storage memory
or USB storage device. When you write or load data via USB storage device, check the
USB cable connection and try again. If you still see this message, the Storage memory/
media/device may have malfunctioned or may be damaged.
• This message appears when a Read-Only file is selected to be overwritten. The file cannot
to be overwritten.
When you delete a folder, this message asks you whether you want to delete all of the files in
that folder. To delete all files in the folder, press the D [+ (YES)] button. To cancel, press the
D [– (NO)] button.
This message will appear when there is insufficient empty space in backup memory. Turn
the power switch off and turn it on again to delete unnecessary backup data.
This message means that automatic adjustment of iAFC is not possible and the settings reset
to their default values. In this case, perform the automatic adjustment once again.
This message means that automatic adjustment of iAFC is not possible because no sound is
output from the rear speaker. In this case if the “Speaker” setting is Off, turn “Speaker” On. If
“Speaker” is set to Normal and headphones are connected, unplug the headphones.
This message will appear to confirm start of the iAFC calibration. When calibrating, a test
tone will sound from the instrument.
This message confirms that the operation has been cancelled.
This message appears when you do the following operation to a protected song:
• Overwrite (protected songs cannot be overwritten)
• Save with a new name (protected songs cannot be used with “Save as” function)
• Delete (this message confirms that the protected song will be deleted)
• Rename (renamed protected songs may not be played back)
This message is displayed following the message “Executing.” The Clavinova’s internal
processing is complete. You may proceed to the next step.
This message appears when a communication error occurred between the instrument and
drive. Check the USB cable connection and try again. If you still see this message, use a drive
whose compatibility has been confirmed by Yamaha (page 122).
The number of drives exceeds the limitation. Two USB storage devices can be connected to
one USB [TO DEVICE] terminal using a hub device. This instrument can recognize up to
four drives in one USB storage device.
The power consumption of the connected USB device exceeds the predetermined value.
When a bus-powered USB hub is used, this message appears. The USB hub must be self-
powered (with its own power source) and the power must be on.
This message appears when the USB storage device is removed from the instrument.
AccessError
AccessError
AllFiles?-->
BackupMemoryFull
CalibrationError
DefaultReset
Calibration
Speaker sound is off
Calibration Sure?-->
Test sound is output.
Canceled
Caution ProtectedSong
Completed
DriveError
DriveNumLimitOver
DrivePowerError
DriveRemoved