Yamaha CLAVINOVA C L P - 3 8 0 - Manual (Page 119)

Keyboard Stand Assembly
CLP-380 Owner’s Manual 119
Appendix
4.
Attach A.
4-1
Adjust the position of A so that the left and right
ends of A will project beyond E and F equally (as
seen from the rear).
4-2
Secure A using two 6 x 16mm short screws from
the rear.
4-3
Secure A using four 6 x 16mm short screws from
the front.
4-4
Firmly tighten the screws from the upper parts
you temporarily fastened in step 2-4 above
(assembly B).
5.
Connect the speaker cord.
5-1
Remove the twist tie attaching the speaker cord.
5-2
Insert the speaker cord plug into the connector so
that the tab extends toward the front when viewed
from the rear.
6.
Connect the pedal cord.
6-1
Insert the pedal cord plug into the [PEDAL]
connector.
6-2
Attach the cord holders to the instrument, then
clip the cord into the holders. At this time, be
careful that the pedal cord isn’t loose between the
plug and cord holder.
6-3
Use a twist tie to bundle the pedal cord.
4-2
4-1
4-3
B
4-4
5-2
6-1
6-2
6-3