Braun Multiquick 5 K 700 - Manual (Page 16)

Cleaning
All parts can be cleaned in the dish-
washer at temperatures up to 65 °C.
Pulp and other residues should not
become dry before the appliance is
cleaned. The appliance may discolour
when processing food with high degree
of pigments (e.g. carrots); use vegetable
oil to clean it, before cleaning with
detergents or in the dishwasher.
17
Please do not dispose of the
product in the household waste
at the end of its useful life.
Disposal can take place at a
Braun Service Centre or at
appropriate collection points
provided in your country.
Subject to change without notice.
Description (SJ 600)
1
Juicer drum
2
Fine grating disc
3
Strainer basket
4
Cover
5
Filling tube
6
Pusher
Before the first use
After unpacking the appliance, please
disassemble it and clean all parts. To
disassemble the appliance proceed as
follows:
• Unlock the strainer basket 3 by turning
it clockwise (a) and wash all parts by
hand.
• Pull the key in the bottom of the juicer
drum 1 as far as it will go (b).
• Turn the juicer drum 1 anti-clockwise
with the key in the bottom of the juicer
drum pulled (b) – until the fine grating
disc 2 is unlocked.
• Then pull the fine grating disc 2 by its
shaft out of the juicer drum 1 (c).
Assembling
• Attach the food processor bowl of your
Braun Multiquick (without the blade) to
the motor block and lock it in place.
For grating:
• Use the fine grating disc 2 only (e).
For juice extracting:
• Insert the fine grating disc 2 into the
juicer drum 1 so that the cut-out
sections in the rim of the fine grating
disc slide over the holding studs in the
juicer drum (d).
• Push the fine grating disc 2 by its
shaft slightly down and turn it clock-
wise until it clicks in (d).
• Check by trying to turn the shaft of the
fine grating disc 2 whether the grating
disc is properly locked. If it is, the shaft
cannot be turned.
• Insert the strainer basket 3 into the
juicer drum 1, and ensure that both
tabs fit into the notches of the drum (f).
• For juice extracting set the assembled
juice extractor on the food processor
bowl drive shaft of your Braun
Multiquick. If you want to grate, set the
fine grating disc 2 only on the drive
shaft of the food processor bowl.
• Place the cover 4 on the Braun
Multiquick food processor bowl so that
the arrow on the cover matches the
arrow on the food processor bowl.
Then turn the cover clockwise until the
nozzle on the cover is in the safety
lock on the motor block of your Braun
Multiquick system and audibly snaps
into place (g). To remove, turn the
cover anti-clockwise.
Extracting juice
Maximum capacity: 500 g or when the
pulp space is full. You can extract juice
from fruits, as well as from vegetables.
• Preparing fruits or vegetables:
First wash or peel the food. Fruits
with pits should always have the pits
removed first. Citrus fruits, as well as
fruits with skin and vegetables (e.g. red
beets and Kiwi-fruits) should be thor-
oughly peeled. Seed fruits (e.g. apples)
can be processed with peels and cores.
• Speed selection:
Please select the setting 7–8 on your
Braun Multiquick.
• Extracting:
Turn on the motor of your Braun
Multiquick. Fill the prepared fruits or
vegetables into the filling tube 5 and
push it down with the pusher 6 (h).
Caution: Always use the pusher. Never
reach into the filling tube while the
motor is running!
Do not overload the appliance.
• Disassembling:
Turn off the motor of your Braun
Multiquick. Turn the cover 4 anti-
clockwise and remove it from the food
processor bowl. Then proceed as
described in the section «Before the
first use». Remove all parts from the
food processor bowl of your Braun
Multiquick. If the fruit pulp is very
dense, pull the disengaged strainer
basket 3 out of the juicer drum 1 by
using the pull rings (f).
Grating
The fine grating device is designed for
very fine grating of food such as hard
cheese (e.g. Italian parmigiano cheese or
Swiss sprintz cheese), horse-radish (e.g.
for horse-radish cream), apples and
carrots (e.g. for baby food).
Important: The fine grating disc is not
suited for grating chocolate.
• Preparing the food for grating:
Fruits and vegetables should be
washed first or peeled. Seeds and
cores should be removed. Cut off the
crust from cheese. The food should be
cut small enough to fit into the filling
tube 5.
• Speed selection:
Please select the setting 7–15 on your
Braun Multiquick.
Note: Hard food should be grated at
higher speeds.
• Grating:
Turn on the motor of your Braun
Multiquick. Fill the prepared food into
the filling tube 5 and push it down
with the pusher 6 (h).
Caution: Always use the pusher. Never
reach into the filling tube while the
motor is running!
• Disassembling:
Turn off the motor of your Braun
Multiquick. Turn the cover 4 anti-clock -
wise and remove it from the food pro-
ces sor bowl. Then remove the fine grat-
ing disc 2 from the food processor bowl.
92266253_K700_S06-116.indd 17 21.05.12 14:10