STIEBEL ELTRON FCR 18-28 - Manual (Page 15)

OpeRatIOn
Safety
EN
GL
ISH
www.stiebel-eltron.com FCR 28 | FCR 18 | 15
1.2 other symbols in this documentation
Note
General information is identified by the symbol shown
on the left.
f f Read these texts carefully.
Symbol meaning
Material losses
(Appliance and consequential losses, environmental pol-
lution)
Appliance disposal
f f This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
1.3 units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
2. safety
2.1 intended use
The appliance is intended for installation in cylinders in a sealed
heating or DHW heating system.
This appliance is designed for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-
domestic environment, e.g. in a small business, as long as it is
used in the same way.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
Using the appliance for heating fluids other than water or water
supplemented with chemicals, such as brine, is also deemed in-
appropriate.
2.2 general safety instructions
WARNING Electrocution
Never spray the appliance with water or other liquids.
WARNING Burns
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
!
WARNING Injury
The appliance may be used by children aged 8 and up
and persons with reduced physical, sensory or mental
capabilities or a lack of experience provided that they
are supervised or they have been instructed on how to
use the appliance safely and have understood the result-
ing risks. Children must never play with the appliance.
Children must never clean the appliance or perform user
maintenance unless they are supervised.
!
Material losses
Condensate can drip from the appliance.
f f Never store objects below the appliance.
Note
The appliance is under pressure.
During the heat-up process, expansion water will drip
from the safety valve.
f f If water continues to drip when heating is complet-
ed, please inform your heating contractor.
2.3 ce designation
The CE designation shows that the appliance meets all essential
requirements according to the:
- Electromagnetic Compatibility Directive
- Low Voltage Directive
2.4 test symbols
See type plate on the appliance.
3. appliance description
The appliance electrically heats DHW and heating water. The
temperature can be adjusted using the temperature selector, de-
pending on the type of appliance or the heating contractor. Once
the selected temperature has been reached the appliance shuts
down. If required, the appliance automatically restarts in single
circuit operation and in dual circuit operation during off-peak tariff
periods / enable times.
The appliance is also protected against frost on the temperature
setting "cold" as long as the power supply is guaranteed. The
appliance switches on in good time and heats the water. The tap
and the mains water supply line are not protected against frost
by the appliance.
!