Garmin NavTalk - Manual (Page 118)

Messages
APPENDIX D
The NavTalk uses an on-screen message indicator to alert you to important informa-
tion. Whenever a “Message” appears, press ENTER to acknowledge the message
and return to the previous page you were viewing . Messages are for system status,
waypoint/route editing, battery condition, incoming call, etc. For your safety, pay
careful attention to all messages. Note: Certain messages indicate that you must return
the NavTalk to your GARMIN dealer for service or repair. Charges for repairs are subject
to terms stated in the GARMIN Limited Warranty on page 115.
switch was turned off. The NavTalk will
switch to a charging mode and/or turn off
automatically when timed out as set in the
‘System” Page.
Leg not Smoothed - The upcoming route
leg is too short for smooth waypoint transitions.
Location Transfer Complete - Your
GPS location DTMF signal has been
received and recorded.
Location Transfer Failed - Your GPS
location DTMF signal tone was not
received. NavTalk sends 5 times before
this message appears.
Maintenance Mode - The cellular sys-
tem is conducting maintenance or run-
ning a test on your phone.
Memory Battery Power Low - The bat-
tery that sustains the user memory is low
and should be replaced by an authorized
service center as soon as possible. Failure
to do so may result in loss of stored data,
including all user waypoints and routes.
Name Already Exits - You have already
entered the same name in the database.
Need Altitude for 2D Nav - The
NavTalk needs altitude input in order to
start or continue 2D navigation.
Need to Select Init Method - You must
select an initialization method so the
unit can locate satellites and obtain a
GPS position fix.
New Missed Call - An unanswered call
was received and stored on the Missed Calls
List. Alarm Clock - The alarm clock time that
was set from the Alarms submenu has been
reached.
Approaching - You are one minute away
from reaching a destination waypoint.
Arrival At - You have reached your desti-
nation waypoint.
Battery Power Low - The battery pack
requires recharging.
Call Answered - an incoming call has
been acknowledged and answered.
Call Blocked - The Call Blocking feature
is enabled.
Call - Press Send - To answer an incom-
ing call, press the send key.
Cellular Needs Alignment - Service to
your unit is required. Contact GARMIN
Product Support.
Data Transfer Complete - The NavTalk
has finished uploading or downloading
information to the connected device.
Degraded Accuracy - The NavTalk’s GPS
accuracy has degraded beyond 500 meters
due to poor satellite geometry or data
quality. Check other navigational sources
to verify the position indicated.
ESN Not Available - Your cellular elec-
tronic serial number is missing. Contact
your authorized GARMIN dealer.
Ignition Power Off - Power to the Vehicular
Adapter has been turned off when the ignition
106
NavTlkOM.qxd 2/3/00 3:47 PM Page 76