Garmin NavTalk - Manual (Page 59)

47
Cell Phone
Reference
SECTION 5
5.6 Setting Up NavTalk Phone Features
Access the Setup Program through the Main
Menu using the Menu button and the ARROW Rocker
Pad to scroll down to Menu Setup. Press ENTER to
access the directories of the Setup program. Directories
are selected by tabs at the top of the screen. Use the
Rocker
RIGHT/LEFT Arrows to scroll from tab to tab.
There are several methods for moving from
field to field and making entries in each directory:
1 . Use the ARROW Rocker Pad to move Up, Down and
from side to side to highlight (cursor to) a selected field.
2. Press ENTER to begin data entry, to “Pop Up” a sub-
menu or activate a button or icon.
3. Enter data using the PHONE KEYPAD or cursor to
a selection from a “Pop Up” menu.
4. Press ENTER to store data and programming selections
for each field and then cursor to the next field.
Start with the first directory titled, “Phone.”
5.6.1 Programming Phone Setup
(Answer Mode, Auto Redial, Auto Data
and Calling Card PIN)
There are three Answer Mode options,
Manual Answer, Auto Answer (Hands-Free, for
headsets), and Auto Pager. When Auto Pager
answers, the microphone is muted and the unit
emits a beep tone to indicate the Auto Pager fea-
ture is active. The caller then enters their phone
number which is placed in the “Missed Calls” list
along with a date/time stamp. Inform frequent
callers about the Auto Pager beep tone signal.
Pressing
SEND pre-empts Auto Pager. Pressing
END before answering any call, cancels Auto
Answer or Auto Pager. These two modes then
resume for subsequent calls. Auto Redial allows
you to redial the number you are calling up to
nine times. Auto Data provides for location data
transmission without ringing the phone or requir-
ing the
SEND key to be pressed, and without dis-
playing messages about location transfer. If data is
not detected within three seconds, the call will
ring for up to 50 seconds and is treated according
to user selection (Auto Answer, Auto Pager, or
Manual Answer). Auto Data selection can be
locked and unlocked using the Security Password.
The three types
of fields used for
programming
the NavTalk:
1. Data Entry
2. Pop - Up Menus
3. Buttons
NavTlkOM.qxd 2/1/00 2:46 PM Page 57