AASTRA 4425 IP Vision for BusinessPhone User Guide - Manual (Page 19)

19 BusinessPhone – Dialog 4425 IP Vision
Start the Phone – Log On/Off
Start the Phone – Log On/Off
All system settings for your IP phone must be set by the system
administrator before you can use the phone.
Connect the required cables.
See section “ Installation ” on page 133.
Note: Depending on the settings in your network and
telephone system, the start up procedure may be different
from phone to phone. Check the display on your phone and
read the required sections in this chapter to continue with
the start up procedure.
When this is done, and the phone is connected to the local network
(LAN), your phone starts the start-up procedure automatically when
connected to the mains.
Notes:
The phone does not work during a power failure. After a
power failure the phone will restart automatically. However,
when a password is requested, you must log on before the
phone can be used again.
Reset the phone
If your phone does not work properly, you can use the following
procedure to reset the phone. This procedure will also clear the Call
list. After the procedure you must log on again to use the phone. н Й #
Press simultaneously for at least one second to reset the
phone.