AASTRA 4425 IP Vision for BusinessPhone User Guide - Manual (Page 20)

Start the Phone – Log On/Off
BusinessPhone – Dialog 4425 IP Vision 20
Start the Phone
Connect the phone to the local network.
See the Installation section, “ Install cables ” on page 136.
If an external power adapter is used:
Connect the adapter to the mains and connect the plug from
the adapter to “POWER” on the underside of your phone.
See the Installation section, “ Install cables ” on page 136.
After a few seconds the Headset key lamp will light for about five
seconds, then the displays shows:
The x indicates a timer counting down seconds. If no key is
pressed during this time, “no change” is selected automatically.
Notes: The administrator mode is used to change the IP
settings of the phone. All administrator mode changes
should be done by your system administrator.
If you want to use the previously stored settings, you can
speed up the procedure by pressing the Loudspeaker key.
Now the display informs you that the phone is connecting to the
server and that the software is loading. This takes about
15 seconds. After a self-test, the phone is ready for log on.
Settings CallList Contacts
User administrator mode to change IP settings
(x)
(No change)