VEGA VEGASON 66 4 … 20 mA_HART four-wire User Manual
Page 16
6 Plug the connection head to the transducer tube. Do not
squeeze any cables. The cylinder is in the correct position,
if the lower notch (2) of the transducer tube is no longer
visible
7 Tighten the screws (5) on the cylinder moderately with a
hexagon spanner (size 4)
8 Loosen terminal screw of the swivelling holder (3) with a
fork spanner (SW 13)
9 Direct the sensor with the swivelling holder to the
measured product
10 Fasten the swivelling holder with screw (3), torque max.
20 Nm
11 Secure screw (3) with lacquer or similar to ensure
permanent tightness of the swivelling holder
12 Rotate the connection head in such a way that the cable
entry points downwards (moisture can drain off). Fasten
the cylinder with screws (5); torque max. 5 Nm
13 Insert the plug at the end of the transducer cable into the
socket on the remote electronics
16
VEGASON 66 - 4 ... 20 mA/HART - four-wire
Mounting
28783
-EN
-060731