VEGA VEGASON 66 4 … 20 mA_HART four-wire - Manual (Page 29)

6 Setup with the indicating and
adjustment module PLICSCOM
6.1 Short description
The indicating and adjustment module PLICSCOM is used for
measured value display, adjustment and diagnosis. It can be
mounted in the following housing versions and instruments:
l
All sensors of the plics ® instrument family, in the single as
well as in the double chamber housing (optionally in the
electronics or connection compartment)
l
External indicating and adjustment unit VEGADIS 61
From a hardware revison …- 01 or higher of PLICSCOM as
well as the respecitive sensor an integrated background
lighting can be switched via the adjustment menu.
4)
. You will
find the hardware revision on the respective type label of
PLICSCOM or the sensor electronics.
Information:
This function is for instruments with StEx, WHG or ship
approval as well as country-specific approvals such as those
according to FM or CSA, available at a later date.
Note:
You will find detailed information on the adjustment in the
operating instructions manual of the "Indicating and adjustment
module PLICSCOM".
6.2 Insert the indicating and adjustment module
The indicating and adjustment module can be inserted in the
sensor and removed at any time. It is not necessary to interrupt
the voltage supply.
Proceed as follows:
1 Unscrew the housing cover
2 Place the indicating and adjustment module in the desired
position on the electronics (you can choose any one of four
different positions - each displaced by 90°)
3 Press the indicating and adjustment module onto the
electronics and turn it to the right until it snaps in.
4) This function will presumably be available from October 2006.
Function/Configuration
Mounting/dismounting the in-
dicating and adjustment
module
Setup with the indicating and adjustment module PLICSCOM
VEGASON 66 - 4 ... 20 mA/HART - four-wire 29
28783
-EN
-060731