VEGA VEGAFLEX 62 Profibus PA - Manual (Page 41)

Status accor-
ding to NE 107 Error code Text message Cause/Rectification
E 017 Adjustment span too small Adjustment not within the specifica-
tion. Carry out the adjustment again,
increasing the distance between
min. and max. adjustment
E 036 No operable software Failed or interrupted software up-
date/Repeat software update
E 042 Hardware error, electronics defec-
tive Exchange the instrument or send it
in for repair
E 043 Hardware error, electronics defec-
tive Exchange the instrument or send it
in for repair
E 113 Communication conflict Exchange the instrument or send it
in for repair
Depending on the failure reason and measures taken, the steps
described in chapter "Set up" must be carried out again, if necessary.
8.3 Exchange or shorten cable/rod
The cable or rod (meas. part) of the probe can be shortened, if
necessary. To loosen the meas. part you need two fork spanners with
spanner width 8.
1 Loosen the measuring component by applying a fork spanner to
the flat surfaces (SW 8), provide counterforce with another fork
spanner (SW 8)
2 Unscrew the loosened measuring component manually
3 Place the enclosed new double washer onto the thread.
Caution:
Make sure that the two components of the double washer remain
together.
4 Screw in a new measuring part manually
5 Exert counterforce with the second fork spanner and tighten the
measuring component on the flat surfaces with a torque of 15 Nm
(11 lbf ft).
Reaction after fault rec-
tification
Exchanging the cable/
rod
VEGAFLEX 62 • Profibus PA 41
8 Maintenance and fault rectification
31839
-
EN
-100426