VEGA VEGAFLEX 62 Profibus PA - Manual (Page 43)

Fig. 24: Shortening the cable probe
8.4 Exchanging the electronics module
If the electronics module is defective, it can be replaced by the user.
In Ex applications only one instrument and one electronics module with
respective Ex approval may be used.
If there is no electronics module available on site, one can be ordered
from the VEGA agency serving you.
The new electronics module must be loaded with the settings of the
sensor. These are the options:
l At the factory by VEGA
l Or on site by the user
In both cases, the sensor serial number is necessary. The serial
numbers are stated on the type label of the instrument, inside the
housing or on the delivery note.
Information:
When loading on site, first of all the order data must be downloaded
from the Internet (see operating instructions manual "Oscillator").
The electronics modules are adapted to the respective sensor and
distinguish also in the signal output or power supply.
Electronics module FX-E.60P suitable for VEGAFLEX 61, 62, 63, 65,
66 - Profibus PA:
l FX-E.60PX (X = without approvals)
l FX-E.60PA (A = approvals CA, DA according to product list)
l FX-E.60PC (C = approvals XM, CX, CM, CK, GX according to
product list)
Sensor serial number
Assignment
Profibus PA
VEGAFLEX 62 • Profibus PA 43
8 Maintenance and fault rectification
31839
-
EN
-100426