VEGA VEGAMIP R62 Receiving unit - Relay - Manual (Page 25)

2 Remove the housing socket from the mounting plate
3
2
1
Fig. 17: Remove the mounting plate from the housing socket
1 Screws
2 Wall mounting plate
3 Cable gland
3 Loop the connection cable through the cable entry on the housing
base
Tip:
The cable gland can be mounted in three positions each displaced by
90°. Simply exchange the cable gland against the blind plug in the
suitable thread opening.
4 Connect the wire ends as described in chapter "Connection plan".
Take note of the numbering.
5 Connect the screen to the internal ground terminal, connect the
outer ground terminal above on the housing to potential equal-
isation
6 Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
7 Place housing with base back on the mounting plate and tighten
the screws
The electrical connection of the sensor to the external housing is
finished.
VEGAMIP R 62 • - Relay 25
5 Connecting to power supply
41912
-
EN
-120228