VEGA VEGAPULS SR 68 Modbus and Levelmaster protocol - Manual (Page 31)

31
5 Connecting to power supply and bus system
VEGAPULS SR 68 • Modbus and Levelmaster protocol
41371-EN-130624
The connection to the display and adjustment module or to the inter-
face adapter is carried out via contact pins in the housing.
Information:
The terminal block is pluggable and can be removed from the
electronics. To do this, lift the terminal block with a small screwdriver
and pull it out. When reinserting the terminal block, you should hear it
snap in.
Proceed as follows:
1. Unscrew the housing cover
2. If a display and adjustment module is installed, remove it by turn-
ing it slightly to the left.
3. Loosen compression nut of the cable entry
4. Remove approx. 10 cm (4 in) of the cable mantle, strip approx.
1 cm (0.4 in) of insulation from the ends of the individual wires
5. Insert the cable into the sensor through the cable entry
Fig. 28: Connection steps 5 and 6 - Single chamber housing
Connection procedure