Cobalt Digital OBSIDIAN 3G 9501-DCDA-3G Downconverter - Manual (Page 23)

9501DCDA-OM (V1.3) 9501-DCDA PRODUCT MANUAL 2-3
Installation and Setup
Installing a Rear I/O Module
Installing a Rear I/O Module
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9501-DCDA is to be installed.
If installing the 9501-DCDA in a slot already equipped with a suitable I/O
module, omit this procedure.
Install a Rear I/O Module as follows:
1. On the frame, determine the slot in which the 9501-DCDA is to be
installed.
2. In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-1.
Figure 2-1 Rear I/O Module Installation
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
1
2