Cobalt Digital OBSIDIAN 3G 9501-DCDA-3G Downconverter - Manual (Page 27)

9501DCDA-OM (V1.3) 9501-DCDA PRODUCT MANUAL 2-7
Installation and Setup
Setting Up 9501-DCDA Network Remote Control
Setting Up 9501-DCDA Network Remote Control
Perform remote control setup in accordance with Cobalt ® reference guide
“Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt ® reference guide Remote
Control User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of Cobalt
®
cards using DashBoard™. (Cobalt ® OGCP-9000 and OGCP-9000/CC
Remote Control Panel product manuals have complete instructions for
setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the
Support>Reference Documents link at www.cobaltdigital.com and then
select DashBoard Remote Control Setup Guide as a download, or contact
Cobalt
® as listed in Contact Cobalt Digital Inc. (p. 1-15).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.