PowerWalker SNMP DP-522 - Manual (Page 16)

Chapter 2. NetAgent UPS Installation
Before using the NetAgent, the proper hardware and software configuration is
necessary. Hardware installation is to connect the NetAgent and UPS and
network. Software configuration includes the IP address.Firmware upgrade. Or
using the Browser or Telnet for configuration.
You could also install the shutdown utility – ClientMate to protect your Windows
operating system. And also could use the UPS management software –
SNMPView, to control and management multiple UPS on the network.
Connect the NetAgent,
UPS and Network
(Chapter 3)
Setup the NetAgent IP address
or update firmware by using
Netility (Chapter 4)
Using the Brower to connect to
NetAgent by using the IP
address of it. (Chapter 5)
Using the Telnet to
configure the NetAgent
UPS settings
(Chapter 6)
Using the shutdown
utility – ClientMate to
connect to NetAgent UPS
(Chapter 7)
The NetAgent management
utility – SNMPView could be used
to manage multiple NetAgent
(Chapter 8)
Fig.4 NetAgent UPS installation flowchart
10