PowerWalker SNMP DP-522 - Manual (Page 57)

2.4 Help
Sub-Menu :
2.4.1 Search NetAgent
2.4.2 Serial Port Debug
2.4.3 Help
2.4.4 About
2.4.1 Search NetAgent
This to display all the found NetAgent within network with its serial number; Mac
Address; Hardware/Firmware version and its IP address. Double clicking on the
highlighted unit to open the webpage of such device.
Refresh
T
his will re-search all the NetAgent in the network
2.4.2 Serial Port Debug
This function is to know the immediate communication between NetAgent and UPS
via serial port
Port Information
This is to configure the communication parameter between NetAgent and UPS.
Parameters are Debug Mode; Port; Speed (Baud), Data Bits;Parity and Stop Bits.
Two encoding formats: ASCII or Hexadecimal.
If Debug mode is set as manually, user may enter its parameter under Send
Contents column.
Sent Information
This column shows the real time sent command
Received Information
This display the response that NetAgent receives from UPS
51