PowerWalker SNMP DP-522 - Manual (Page 61)

Fig.42 NetAgent Telnet window
1. Set IP Address.
This function allows you to setup IP Address, Gateway Address, Subnet Mask
parameters.
2. Set SNMP MIB System.
This function allows you to set the MIB system group parameters.
3. Set SNMP Access Control.
This function allows you to set the Manager IP, Community, Access Permission.
Note:The configuration of ‘Set SNMP Access Control’ is only used for SNMP Network Manager.
4. Set SNMP Trap Notification.
If you want to use a PC and perform the ‘Trap’ function of SNMP manager to
manage UPS through Net Agent, the IP address of the PC must be added in this list of
Net Agent.
Note:The configuration of ‘Set SNMP Trap Receiver’ is only used for SNMP Network Manager.
5. Set UPS Properties.
This allows you to setup the Communication Type of UPS, UPS Device Name and
Battery Replacement Date.
6. Set UPS Devices Connected.
This allows you to setup the System Name, Rating which connected., Connected.
7. Set System Time & Time Server.
This allows you to setup the System date, time and two time servers.
8. Set Web and Telnet User Account.
This is allows to set users account’s authority.
9. Set E-mail.
This is allows to set e-mail accounts to receive power event notification for emergency
management.
a. Reset Configuration to Default.
Set all values to their default settings.
b. Save & Reboot.
Save the current configuration data, including any changes you have made, and
reboot the Net Agent.
0. Exit Without Saving.
Exit, all configuration changes will be lost.
55