PowerWalker SNMP DP-522 - Manual (Page 29)

10 Second Test
This to perform 10 seconds UPS self test
Deep Battery Test
This function is to execute XX minute deep battery test
Test Until Battery Low
When execute, UPS will test Battery until battery low
Cancel Test
This function is to abort a test when it is executing.
Turn off UPS when AC failed/Reboot UPS
Selecting ' Turn off UPS when AC failed' will turn off the UPS. You can reboot the UPS by
selecting ' Reboot UPS'
.
Put UPS in Sleep mode for __ minutes/Wake up UPS
When the UPS is put into Sleep mode, it will not provide power. The UPS will provide
power again after Sleep mode time is complete.
Wake up UPS
When execute such command, UPS will be awake from sleep
Reboot UPS
When execute such command, UPS load would start over.
UPS Buzzer On/Off
This is to trigger UPS buzzer On. If its ON already, execute such command will set it OFF
Fig.19 Remote Control
23