PowerWalker SNMP DP-522 - Manual (Page 7)

Chapter1. Introduction
Section1. Features
NetAgent is a new generation SNMP (Simple Network Management Protocol)
monitoring product. Not only could remote control the UPS and get the current
status of it, the NetAgent II –3Ports also could provide other functions, ex.
connect to Modem or GSM Modem to make the monitoring possible when
there is no permanent connection to Internet and sens SMS notification . The
NetAgent II – 3Ports could also been used to connect to ‘NetFeeler II’, to get
the temperature, humidity and water conditions. To get the condition of Smoke
detector, Gas detector, door and window detector are also possible.
This product is for “Contact Closure” and “RS232” interface UPS. The
communication protocol includes the Contact Closure, RS232[MegaTec],
RS232[Phoenixtec], SEC 2400, SEC 9600, Three Phase, Powerware, Smart
APC, EMERSON. User could also provide their own protocol to build in.
NetAgent provides a simple and easy installation procedure. CD provides
along with NetAgent offers several softwares to allow the user to configure IP
address; central monitoring and multi shutdown on different operating systems.
Other advance configurations could be accomplished in the Web browser.
Features:
n Provide SNMP MIB to monitor & control UPS
o Auto-sense 10M/100M Fast Ethernet
p Manage and configure via Telnet, Web Browser or NMS
q Support TCP/IP, UDP, SNMP, Telnet, SNTP, PPP, HTTP, SMTP Protocol
r Providing easy setup and upgrade tools via MS-Windows, just a few
seconds to finish IP setting, about 1.5 minutes to upgrade firmware.
s Send SNMP TRAP ; E-mail and SMS for events notification.
t Auto email daily UPS history report
u Matches with shutdown software to protect computer’s file saving and shut
down safely
v NetAgent II – 3Ports : Environment Measurement (Optional Kits), External
modem dial in/out via PPP protocol or GSM/GPRS Modem
1