QTECH QSW-8300 Инструкция по настройке - Manual (Page 16)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
15
<0-86400>|]
no rate-violation
the rate of the received packet violates the
packet reception rate, shut down this port and
configure the recovery time, the default is 300s.
The no command will disable the rate-violation
function of a port.
Global Mode
port-rate-statistics interval [<interval -
value>]
Configure the interval of port-rate-statistics.
3. Virtual cable test
Command Explanation
Port Configuration Mode
virtual-cable-test Test virtual cables of the port.
1.3 Port Configuration Example
Port Configuration Example
No VLAN has been configured in the switches, default VLAN1 is used.
Switch Port Property
Switch1 1/0/7 Ingress bandwidth limit: 50 M
Switch2 1/0/8 Mirror source port
1/0/9 100Mbps full, mirror source port
1/0/10 1000Mbps full, mirror destination port
Switch3 1/0/12 100Mbps full
The configurations are listed below:
Switch1:
1/0/7
Switch 2
Switch 3
1/0/9
1/0/12 1/0/8
1/0/10
Switch 1