QTECH QSW-8300 Инструкция по настройке - Manual (Page 299)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
298
(2) Configure VRRP priority
Command Explanation
VRRP protocol configuration mode
priority <priority> Configures VRRP priority.
(3) Configure VRRP Timer intervals
Command Explanation
VRRP protocol configuration mode
advertisement-interval <time> Configures VRRP timer value (in seconds).
(4) Configure VRRP interface monitor
Command Explanation
VRRP protocol configuration mode
circuit-failover {IFNAME | Vlan <ID> }
<value_reduced>
no circuit-failover
Configures VRRP interface monitor, the "no
circuit-failover" removes monitor to the
interface.
31.3 VRRP Typical Examples
As shown in the figure below, SwitchA and SwitchB are Layer three Ethernet Switches in the
same group and provide redundancy for each other.
VRRP Network Topology
Configuration of SwitchA:
SwitchA(config)#interface vlan 1
SwitchA (Config-if-Vlan1)# ip address 10.1.1.1 255.255.255.0
SwitchA (config)#router vrrp 1
SwitchA(Config-Router-Vrrp)# virtual-ip 10.1.1.5
SwitchA(Config-Router-Vrrp)# interface vlan 1
SwitchA(Config-Router-Vrrp)# enable
switchA
switchB
Interface vlan1 Interface vlan1