QTECH QSW-8300 Инструкция по настройке - Manual (Page 255)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
254
SwitchB(config)#ip igmp snooping
SwitchB(config)#ip igmp snooping vlan 100
SwitchB(config)#ip igmp snooping vlan 100 mrouter interface ethernet 1/0/1
Multicast Configuration
The same as scenario 1
IGMP Snooping listening result:
Similar to scenario 1
Scenario 3: To run in cooperation with layer 3 multicast protocols.
switch which is used in Scenario 1 is replaced with ROUTER with specific configurations
remains the same. And multicast and IGMP snooping configurations are the same with what it
is in Scenario 1. To configure PIM-SM on ROUTER, and enable PIM-SM on vlan 100 (use the
same PIM mode with the connected multicast router)
Configurations are listed as below:
switch#config
switch(config)#ip pim multicast-routing
switch(config)#interface vlan 100
switch(config-if-vlan100)#ip pim sparse-mode
IGMP snooping does not distribute entries when layer 3 multicast protocol is enabled. It only
does the following tasks.
Remove the layer 2 multicast entries.
Provide query functions to the layer 3 with vlan, S, and G as the parameters.
When layer 3 IGMP is disabled, re-enable distributing layer 2 multicast entries.
By looking up the layer 3 IPMC entries, it can be found that ports can be indicated by the layer
3 multicast entries. This ensures the IGMP snooping can work in cooperation with the layer 3
multicast protocols.
28.10.4 IGMP Snooping Troubleshooting
On IGMP Snooping function configuration and usage, IGMP Snooping might not run properly
because of physical connection or configuration mistakes. So the users should note that:
Make sure correct physical connection
Activate IGMP Snooping on whole configuration mode (use ip igmp snooping)
Configure IGMP Snooping at VLAN on whole configuration mode ( use ip igmp snooping
vlan <vlan-id>)
Make sure one VLAN is configured as L2 common checker in same mask, or make sure