QTECH QSW-8300 Инструкция по настройке - Manual (Page 268)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
267
Configure the switch as a candidate BSR
Configure the switch as a candidate RP
Configure static RP
Configure the cache time of kernel multicast route
Disable the PIM-SM protocol
1. Enable PIM-SM protocol
The PIM-SM protocol can be enabled on QTECH series Layer 3 switches by enabling PIM6 in
global configuration mode and then enabling PIM-SM for specific interfaces in the interface
configuration mode.
Command Explanation
Global Configuration Mode
[no] ipv6 pim multicast-routing
To enable the PIM-SM6 protocol for all the
interfaces (However, in order to make PIM-SM work
for specific interfaces, the following command
should be issued). (required)
Make the PIM-SM protocol work for specific interfaces
Command Explanation
Interface Configuration Mode
[no] ipv6 pim sparse-mode [passive]
To enable PIM-SM for the specified interface.
The no form of this command will disable the PIM-
SM protocol (required).
2. Configure static multicast routing entries
Command Explanation
Global Configuration Mode
ipv6 mroute <X:X::X:X> <X:X::X:X>
<ifname> <.ifname>
no ipv6 mroute <X:X::X:X>
<X:X::X:X> [<ifname> <.ifname>]
To configure a static multicast routing entry. The no
form of this command will remove the specified
static multicast routing entry.
3. Configure the additional parameters for PIM-SM
(1) Configure parameters for PIM-SM interfaces
1) Configure the interval for PIM-SM hello messages
Command Explanation
Interface Configuration Mode
ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
To configure the interval for PIM-SM hello
messages. The no form of this command restores