QTECH QSW-8300 Инструкция по настройке - Manual (Page 174)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
173
4. To enable DHCPv6 prefix delegation server function on port
Command Explanation
Interface Configuration Mode
ipv6 dhcp server <poolname> [preference
<value>] [rapid-commit] [allow-hint]
no ipv6 dhcp server <poolname>
To enable DHCPv6 server function on specified
port, and binding used DHCPv6 address pool.
24.5 DHCPv6 Prefix Delegation Client Configuration
DHCPv6 prefix delegation client configuration task list as below:
To enable/disable DHCPv6 service
To enable DHCPv6 prefix delegation client function on port
1. To enable/disable DHCPv6 service
Command Explanation
Global Mode
service dhcpv6
no service dhcpv6
To enable DHCPv6 service.
2. To enable DHCPv6 prefix delegation client function on port
Command Explanation
Interface Configuration Mode
ipv6 dhcp client pd <prefix-name> [rapid-
commit]
no ipv6 dhcp client pd
To enable client prefix delegation request
function on specified port, and the prefix
obtained associate with universal prefix
configured.
24.6 DHCPv6 Configuration Examples
Example1:
When deploying IPv6 networking, QTECH series switches can be configured as DHCPv6
server in order to manage the allocation of IPv6 addresses. Both the state and the stateless
DHCPv6 are supported.
Topology:
The access layer use Switch1 switch to connect users of dormitory buildings; Switch2 is
configured as DHCPv6 relay delegation in primary aggregation layer ; Switch3 is configured as