QTECH QSW-3400 Инструкция по настройке - Manual (Page 297)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
296
Global Mode
ip igmp snooping vlan <vlan-id>
no ip igmp snooping vlan <vlan-id>
Enable the IGMP Snooping function on the
multicast VLAN. The no form of this command
disables the IGMP Snooping on the multicast
VLAN.
ip igmp snooping
no ip igmp snooping
Enable the IGMP Snooping function. The no
form of this command disables the IGMP
snooping function.
3. Configure the MLD Snooping
ipv6 mld snooping vlan <vlan-id>
no ipv6 mld snooping vlan <vlan-id>
Enable MLD Snooping on multicast VLAN; the
no form of this command disables MLD
Snooping on multicast VLAN.
ipv6 mld snooping
no ipv6 mld snooping
Enable the MLD Snooping function. The no
form of this command disables the MLD
snooping function.
38.3 Multicast VLAN Examples
Function configuration of the Multicast VLAN
As shown in the figure, the multicast server is connected to the layer 3 switch switchA through
port 1/1 which belongs to the VLAN10 of the switch. The layer 3 switch switchA is connected
with layer 2 switches through the port1/10, which configured as trunk port. On the switchB the
VLAN100 is configured set to contain port1/15, and VLAN101 to contain port1/20. PC1 and
PC2 are respectively connected to port 1/15 and1/20. The switchB is connected with the
switchA through port1/10, which configured as trunk port. VLAN 20 is a multicast VLAN. By
configuring multicast vlan, the PC1 and PC2 will receives the multicast data from the multicast