QTECH QSW-3400 Инструкция по настройке - Manual (Page 333)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
332
1. Enable 802.1x function
Command Explanation
Global Mode
dot1x enable
no dot1x enable
Enables the 802.1x function in the switch and ports; the no
command disables the 802.1x function.
dot1x privateclient enable
no dot1x privateclient enable
Enables the switch force client software using private
802.1x authentication packet format. The no command will
disable this function.
dot1x user free-resource
<prefix> <mask>
no dot1x user free-resource
Sets free access network resource for unauthorized dot1x
user. The no command close the resource.
dot1x unicast enable
no dot1x unicast enable
Enable the 802.1x unicast passthrough function of switch;
the no operation of this command will disable this function.
2. Access management unit property configuration
(1) Configure port authentication status
Command Explanation
Port Mode
dot1x port-control
{auto|force-authorized|force-
unauthorized }
no dot1x port-control
Sets the 802.1x authentication mode; the no command
restores the default setting.
(2) Configure port access management method
Command Explanation
Port Mode
dot1x port-method {macbased | portbased
| userbased {standard | advanced}}
no dot1x port-method
Sets the port access management method;
the no command restores MAC-based access
management.
dot1x max-user macbased <number>
no dot1x max-user macbased
Sets the maximum number of access users for
the specified port; the no command restores
the default setting of allowing 1 user.
dot1x max-user userbased <number>
no dot1x max-user userbased
Set the upper limit of the number of users
allowed accessing the specified port, only
used when the access control mode of the
port is userbased; the no command is used to
reset the limit to 10 by default.