QTECH QSW-3400 Инструкция по настройке - Manual (Page 67)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
66
6. Manage cluster network with web
7. Manage cluster network with snmp
4.3 Examples of Cluster Administration
Scenario:
The four switches SW1-SW4, amongst the SW1 is the command switch and other switches
are member switch. The SW2 and SW4 is directly connected with the command switch, SW3
connects to the command switch through SW2.
cluster reset member [id <member-
id> | mac-address <mac-addr>]
In the commander switch, this command is used to
reset the member switch.
cluster update member <member-
id> <src-url> <dst-filename>[ascii |
binary]
In the commander switch, this command is used to
remotely upgrade the member switch. It can only
upgrade nos.img file.
Command Explanation
Global Mode
ip http server Enable http function in commander switch and member switch.
Notice: must insure the http function be enabled in member switch
when commander switch visiting member switch by web. The
commander switch visit member switch via beat member node in
member cluster topology.
Command Explanation
Global Mode
snmp-server enable Enable snmp server function in commander switch and member
switch.
Notice: must insure the snmp server function be enabled in
member switch when commander switch visiting member switch
by snmp. The commander switch visit member switch via configure
character string <commander-community>@sw<member id>.