QTECH QSW-3400 Инструкция по настройке - Manual (Page 430)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
429
Switch(config)#vlan 5
Switch(Config-Vlan5)#remote-span
Switch(Config-Vlan5)#exit
Switch(config)#interface ethernet 1/9
Switch(Config-If-Ethernet1/9)#switchport mode trunk
Switch(Config-If-Ethernet1/9)#exit
Switch(config)#interface ethernet 1/10
Switch(Config-If-Ethernet1/10)#switchport access vlan 5
Switch(Config-If-Ethernet1/10)#exit
Solution 2:
Source switch:
Interface ethernet 1/1 is the source port.
Interface ethernet 1/2 is the TRUNK port, which is connected to the intermediate switch. The
native VLAN should not be a RSPAN VLAN.
Interface Ethernet 1/3 is a reflector port. The reflector port belongs the RSPAN VLAN, it is
access port or TRUNK port of the RSPAN VLAN.
RSPAN VLAN is 5.
Switch(config)#vlan 5
Switch(Config-Vlan5)#remote-span
Switch(Config-Vlan5)#exit
Switch(config)#interface ethernet1/2
Switch(Config-If-Ethernet1/2)#switchport mode trunk
Switch(Config-If-Ethernet1/2)#exit
Switch(config)#interface ethernet 1/3
Switch(Config-If-Ethernet1/3)#switchport mode trunk
Switch(Config-If-Ethernet1/3)#exit
Switch(config)#monitor session 1 source interface ethernet1/1 rx
Switch(config)#monitor session 1 reflector-port ethernet1/3
Switch(config)#monitor session 1 remote vlan 5
Intermediate switch:
Interface ethernet1/6 is the source port which is connected to the source switch.
Interface ethernet1/7 is the destination port which is connected to the destination switch. The
native VLAN of the port should not be configured as RSPAN VLAN, or the mirrored data may
not be carried by the destination switch.
RSPAN VLAN is 5.