QTECH QSW-3400 Инструкция по настройке - Manual (Page 48)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
47
 Interface and datalink layer protocol is Up (use the “show interface” command), and the
connection between the switch and host can be verified by ping (use “ping” command).

The switch enabled SNMP Agen
t server function (use “snmp-server” command)
 Secure IP for NMS (use “snmp-server securityip” command) and community string (use
“snmp-server community” command) are correctly configured, as any of them fails,
SNMP will not be able to communicate with NMS properly.
 If Trap function is required, remember to enable Trap (use “snmp-server enable traps”
command). And remember to properly configure the target host IP address and
community string for Trap (use “snmp-server host” command) to ensure Trap message
can be sent to the specified host.
 If RMON function is required, RMON must be enabled first (use “rmon enable”
command).
 Use “show snmp” command to verify sent and received SNMP messages; Use “show
snmp status” command to verify SNMP configuration information; Use “debug snmp
packet” to enable SNMP debugging function and verify debug information.
If users still can’t solve the SNMP problems, Please contact our technical and service center.
2.5 Switch Upgrade
Switch provides two ways for switch upgrade: BootROM upgrade and the TFTP/FTP upgrade
under Shell.
2.5.1 Switch System Files
The system files includes system image file and boot file. The updating of the switch is to
update the two files by overwrite the old files with the new ones.
The system image files refers to the compressed files of the switch hardware drivers, and
software support program, etc, namely what we usually call the IMG update file. The IMG file
can only be saved in the FLASH with a defined name of nos.img
The boot file is for initiating the switch, namely what we usually call the ROM update file (It can
be compressed into IMG file if it is of large size). In switch, the boot file is allowed to save in
ROM only. Switch mandates the name of the boot file to be boot.rom.
The update method of the system image file and the boot file is the same. The switch supplies
the user with two modes of updating: 1. BootROM mode; 2. TFTP and FTP update at Shell
mode. This two update method will be explained in details in following two sections.