SENA Parani100 - Manual (Page 12)

- 12 - 12
3. Installation
3.1 Network Settings
(1) Parani100 power-up; ‘POWER’and ‘STATUS’LEDs display green
(2) Parani100 network configuration: connect Parani100 to PC via RS232 cable
(3) Open HyperTerminal
(4) Set PC COM port;
Baud rate 115200 / 8 Data bit / non-parity / 1 stop bit / no hardware flow control
RS232 Mode
Parani100 Installation
Network Configuration Serial Port Configuration
Change of DIPswitch
Configuration via serial cable
Mode configuration
Connection from Bluetooth Terminal device
(Parani10)
TCP/IP mode