Appendix a. control commands, A .1 basic commands – SENA Parani100 User Manual
Page 50
- 50 -
50
Appendix A. Control Commands
Parani100 can be configured/controlled by Control commands through control TCP port.
Parani100 software is the GUI version of Control commands for ease of use by customers.
As
all of the control commands, in Parani100 software, are listed in the bottom window, users may
see and understand how each of the commands is used.
Using control TCP port, users may develop software to control Parani100 by themselves. This
means users do not need to equip expensive Bluetooth development kit but may develop
Bluetooth solution to meet each needs by simple commands. Parani100 is cost-effective and
timesaving solution for users.
A .1 Basic Commands
USER <username>
:
To enter Log in Name
Ex.:
USER admin
+OK Password required
PASS <password> [new password]
:
To enter or change the Password for logging in.
Below Example shows how to change Password from ‘11111’to ‘1234’
Ex:
PASS 11111
+OK User Authenticated
PASS 11111 1234
+OK
QUIT
:
To quit the communication with Parani100
Ex.:
QUIT
+OK
Disconnected
MODE [server|client|vertex|hub|repeater|rs232]
:
To check or change the current Operation MODE of Parani100.
If any of Bluetooth devices are connected to Parani100, MODE change is