SENA ProBee-ZE20S - Manual (Page 53)

53 ProBee-ZE20S User Guide Rev.1.10
Figure 6-3 Example #1: 1 Coordinator, 1 Router and 1 End-Device
6.4.1 Coordinator Configuration
Hardware configuration for the coordinator is as follows:
 Set the HOST switch to USB
 Close the USB_PWR jumper and open the RS_PWR and BATT_PWR jumpers.
 Connect a USB cable between a host computer and the coordinator
The AT commands for the coordinator are as follows:
AT+NODETYPE=1
OK
AT+PANID=7772
OK
ATS11=1
OK
AT+LONGADDR
0001950000000001
OK
ATZ
OK
6.4.2 Router Configuration
Hardware configuration for the coordinator is as follows:
 Set the ADC_2 and ADC_3 switch to TEMP_SENS and LIGHT_SENS
The AT commands for the router are as follows:
AT+NODETYPE=2
OK