SENA ProBee-ZE20S User Manual
Page 57
57
ProBee-ZE20S User Guide Rev.1.10
Close the USB_PWR jumper and open the RS_PWR and BATT_PWR jumpers.
Connect a USB cable between a host computer and the coordinator
The AT commands for the coordinator are as follows:
AT+NODETYPE=1
# Set node type as Coordinator
OK
# Response
AT+PANID=7772
# Set 16-bit PAN ID (7772)
OK
# Response
6.6.2
Router Configuration
Hardware configuration for the coordinator is as follows:
Set the ADC_2 and ADC_3 switch to TEMP_SENS and LIGHT_SENS
Figure 6-6 Hardware Configuration
The AT commands for the router are as follows:
AT+NODETYPE=2
# set node type as Router
OK
# Response
AT+PANID=7772
# Set same 16-bit PAN ID (7772) as Coordinator
OK
# Response
AT+GPIO=55555000000440055 # Set ADC_2 and ADC_3 as Analog Input
# OR
ADC_2
ADC_3