SENA ProBee-ZE20S - Manual (Page 84)

84 ProBee-ZE20S User Guide Rev.1.10
9.1 Display Options
9.1.1 S11
Description
Get/Set the display mode. It determines to display incoming message in command
mode.
Execute ATS11?<CR> ATS11=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range 0 - 1
9.1.2 S12
Description Get/Set the command echo mode.
Execute ATS12?<CR> ATS12=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range 0 – 1
9.1.3 S13
Description Get/Set the command responses mode.
Execute ATS13?<CR> ATS13=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range 0 - 1
9.1.4 S14
Description
Get/Set the LED mode. It causes the LED operation if the device is ZE20S set
GPIO15, 16 to specific functionality.
0: LEDs are always OFF regardless of configuration or status.
1: LEDs are OFF when the node is under sleep status.
2: LEDs always operate by the case.
Execute ATS14?<CR> ATS14=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 1
Range 0 - 2