SENA ProBee-ZE20S - Manual (Page 56)

56 ProBee-ZE20S User Guide Rev.1.10
AT+PANID=7772
OK
AT+GPIO=33333333333333333
OK
AT+LONGADDR
0001950000000003
OK
ATZ
OK
6.5.3 Turning on/off the LEDs
The AT commands to control the LEDs are as follows:
AT+REMOTE=0001950000000003,AT+DIO=00000000000000000
OK
AT+REMOTE=0001950000000003,AT+DIO=11111111111111111
OK
6.6 Configuration Example #3: Light Sensor and Temperature Sensor
Here is an example sampling light sensor data and temperature sensor data. This example can be
described as follows:
 One ZE20S module acts as a coordinator and it is connected to a host computer via serial cable.
 One ZE20S modules act as a router.
 Sampling light sensor data and temperature sensor data in many ways
Figure 6-5 Example #3: Light Sensor and Temperature Sensor
6.6.1 Coordinator Configuration
Hardware configuration for the coordinator is as follows:
 Set the HOST switch to USB