GE Industrial Solutions DV-300 DC Quick Start - Manual (Page 29)

DV-300 Adjustable Speed Drives
—————— Quick Start up guide ——————
QS
29
= terminals.
If mains commands = digital, enable is commanded
if terminal 12 is connected to + 15 to +30 VDC
and enable is set to 1 using a LAN command, using
the PC configurator Control Window, or through
the keypad by pressing START UP, press ENT,
press the down arrow until Enable drive is shown,
press ENT twice.
Ilimit -> when lit, the drive is in current limit, or torque
current limit.
Zero speed -> when lit, the drive speed feedback is
detected to be below the adjustable zero speed
threshold.
+ torque LED -> when lit, the LED signals that the
current feedback magnitude is in a direction to
provide positive motor output torque.
Under light load conditions, the LEDs may flicker
between + and - torque.
This is the speed regulator generating + and - torque
current to accurately regulate speed.
- torque LED -> when lit, the LED signals that the
current feedback magnitude is in a direction to
provide negative motor output torque.
14 d. Keypad menu structure
The drive keypad menu structure is similar to DOSä
and Windowsä file structures.
There is a list of main menu headings. Selecting a
heading allows the user to funnel down to a select a
finer defined group of headings or parameters.
The major menu structure of the DV-300 is, in
capital letters:
GE DRIVE DV-300
DRIVE STATUS
press the down key
GE DRIVE DV-300
START UP
press the down key
press the down key
press the down key
press the down key
press the down key
GE DRIVE DV-300
RAMP
press the down key
press the down key
GE DRIVE DV-300
CURRENT REGULAT
press the down key
GE DRIVE DV-300
FLUX REGULATION
press the down key
press the down key
press the down key
press the down key
press the down key
press the down key
press the down key
press the down key
press the down key