GE Industrial Solutions Neutral Mounting Kit - TNK200 - Manual

g
DEH44150 Installation Instructions
Neutral mounting kit
Catalog number – TNK200
1
Introduction
This bulletin provides instructions for
installing Neutral lug kit – TNK200 on all
GE Double throw safety switch rated
200A.
WARNING: Hazard of electrical shock or
burn. Turn off power before working
inside this equipment.
Description
This neutral kit consists of the following
parts:
1. One (1) Neutral assembly
2. Two (2) 10-32 X 1/4” mounting screws
3. One (1) Card for screw
4. One (1) 12-24 X 1-3/16” bonding screw
Mounting Instruction
1. Tighten item 2 (Mounting screws) in to
mounting hole in the enclosure. Ref. Fig 1
2. For bonding, Insert item 4 (Bonding
screw) through hole in neutral & thread
screw in to tapped hole in mounting
bracket of neutral assembly. Ref. Fig 2
Wire range: 6 – 250MCM CU/AL
g
General Electric Company
41 Woodford Ave., Plainville, CT. 06062
DEH44150 R01 08/07 © 2007 General Electric
Visit us on the web at www.GEindustrial.com
Fig 1
Fig 2
These instructions do not purport to cover all details or variations in equipment nor to provide
for every possible contingency to be met in connection with installation operation or
maintenance. Should further information be desired or should particular problems arise which
are not covered sufficiently for the purchaser’s purposes, the matter should be referred to the GE
Company.
GE Consumer & Industrial