GE Industrial Solutions SG Series 750 T12 UL S2 User Manual - Manual (Page 39)

Modifications reserved Page 39/71
OPM_SGS_USM_M75_M75_2US_V010.doc User Manual SG Series 750 UL S2 & SG Series 750 T12 UL S2
` Home\Setup\User
MODEM
Tel 2 : 2
Tel 2 enabled : N
Tel 3 : 3
Tel 3 enabled : N
Tel 4 : 4
Tel 4 enabled : N
V
Modem screen 2
Tel 2
It records the second dial-out number.
Tel 2 enabled
This parameter Y/N specifies if the second telephone
number will be used for dial-out.
Tel 3 It records the third dial-out number.
Tel 3 enabled This parameter Y/N specifies if the third telephone number will be used for dial-out.
Tel 4 It records the fourth dial-out number.
Tel 4 enabled This parameter Y/N specifies if the fourth telephone number will be used for dial-out.
` Home\Setup\User
PRINTER
Baud Rate : 2400
Parity : 0
Bits : 8
Handshake : XON
V
Printer setup screen
The UPS is capable of communicating to a serial printer, to
printout disparate information.
Please be sure to have a serial printer with a serial RS232
interface.
This is the only printer-interface supported by the UPS.
Baud Rate
This parameter controls the baud rate used for data
transmission.
Parity This parameter controls the parity used for data transmission.
Odd (O) even (E) and “No Parity” (NO) can be selected.
In case “No Parity” (NO) has been set, automatically the parameter “8 bits“ is used, independently
of the value of “Bits“ set.
Bits This parameter controls the length of the data word on the serial line during data transmission.
Handshake This parameter is used to determine the communication protocol used when printing.
Valid values are “XON” standing for the XON/XOFF protocol or “NO” standing for any protocol.
NOTE !
Please configure your printer with the following parameters: 2400/8/N (2400 bauds/sec, 8
bits, no parity).
` Home\Setup\User
PRINTER COMMANDS
Print Measures : N
Print Alarms : N
Print Parameters : N
Print All : N
V
Printer command screen
Print Measures This Y/N parameter is used to print only
the measurement data.
Print Alarms This Y/N parameter is used to print only
the sequence of all Alarms/Events.
Print Parameters This Y/N parameter is used to print only
the list of User and Service Parameters.
Print All This parameter Y/N is used to print all the available information in the sequence metering,
alarms, user and service parameters.