GE Industrial Solutions SG Series 750 T12 UL S2 User Manual - Manual (Page 67)

Modifications reserved Page 67/71
OPM_SGS_USM_M75_M75_2US_V010.doc User Manual SG Series 750 UL S2 & SG Series 750 T12 UL S2
8 OPTIONS
8.1 COMMUNICATION OPTIONS
3-ph SNMP/WEB plug-in adapter
SNMP - Simple Network Management Protocol
The 3-ph SNMP/WEB plug-in adapter is an interface to the Ethernet Network, and
provides UPS information via the standard SNMP Protocol (UPS-MIB (RFC-1628); GE
Single MIB; GE Parallel MIB).
The UPS can therefore be managed by a Network Management System (NMS) or by
our applications (for instance GE Power Diagnostics, GE Data Protection or GE Service
Software), which uses this information to determine the state of the UPS in order to
guarantee safe and orderly shutdown of the server, when needed.
GE Power Diagnostics
GE Power Diagnostics is an anytime, anywhere concept in UPS status monitoring and
alarm notification that has been successfully implemented in numerous of
installations supporting up to multi-hundred UPS.
Based on the leading Intelligent Remote Information System IRIS all GE UPS types as
well as 3rd party UPS are supported.
Accessing the latest site information via Web and being alerted by Email, SMS or Fax, it
enables the user to make timely decisions in case of changing critical conditions.
With comprehensive data collection and analysis IRIS is not only a remote monitoring
& diagnostics (RM&D) system but, the core of the integrated service offering GE Power
Diagnostics.
GE Data Protection
GE Data Protection software can communicate with the UPS over RS-232, USB or
SNMP to receive status information and measurement values of the UPS.
In case of a critical condition (time on battery, remaining battery autonomy time or
low battery) for the load, the software starts a controlled shutdown.
An enhanced alarm management system provides the possibility to start
applications, send messages, and send e-mails for every upcoming or disappearing
alarm.
Mute Test
SGT5000_OPT_RMS_01
Stop
Alarm
g
GE Digital Energy
Remote Signaling Box (RSB)
Equipped with mimic diagram, general alarm, stop operation, alarm reset and lamp.
8.2 OPTIONS IN UPS CABINET
RPA Kit
Redundant Parallel Architecture
Up to 6 units parallel possible for redundancy or capacity in RPA configuration.
eBoost™ Operation Mode
High efficiency operating mode, where the load is supplied directly by utility and
automatically transferred to inverter if the voltage is out of prescribed tolerances.
11 th harmonic filter
Located inside UPS cabinet.