GE Industrial Solutions IEMi - Manual (Page 16)

3.1.5 Commands
The COMMANDS mode is entered any time the “CMDS” button is pressed.
Allows the user to execute UPS operation commands.
In this mode the buttons perform the following functions:
Return to HOME screen.
Scrolls forward to the next screen.
V Scrolls forward to the next line.
 Confirm the selection made.
It is possible to view any pushbutton functional description by pushing the button for more than 3
seconds.
` Home\Commands Commands screen 1
LAMP TEST
Signaling LEDs test and buzzer test (all LED should be lit and
blinking and the acoustical alarm should be activated).
INVERTER ON
Command to switch the inverter.
INVERTER OFF
Command to shutdown the inverter.
COMMANDS
LAMP TEST
INVERTER ON
INVERTER OFF
RECTIFIER ON
V 
RECTIFIER ON
Command to switch the rectifier.
Only for Service Center, the command access is protected
by a code.
NOTE !
When IEMi Operation Mode is enabled, control of Inverter status and selection of the
feed path is done autonomously by the UPS control logic.
Therefore, Inverter ON / Inverter OFF commands are disabled when IEMi Operation
Mode is enabled.
Modifications reserved Page 16/24
OPM_OPT_IEM_iXX_XXX_XGB_V010.doc User Manual IEMi - Intelligent Energy Management integrated