2 control panel – lcd display, Control panel – lcd display – GE Industrial Solutions IEMi User Manual
Page 17
3.2 CONTROL PANEL – LCD DISPLAY
Fig. 3.2-1 Control panel – LCD display: UPS functioning in IEMi Operation Mode
Key to switch the Inverter ON ( I )
NOTE !
inverter on/off
When IEMi Operation Mode is enabled, control of Inverter status
and selection of the feed path is done autonomously by the UPS
control logic.
Therefore, Inverter ON / Inverter OFF commands are disabled
when IEMi Operation Mode is enabled.
Key for Inverter shutdown ( O )
Press the key to transfers the Load to Utility/Mains.
Keep pressed for 5 seconds to shutdown the Inverter.
This key is also used as the EPO (Emergency Power Off) reset.
inverter on/off
NOTE !
Inverter OFF command is disabled when IEMi Operation Mode is
enabled.
Furthermore, all functions associated with the ( O ) key are
disabled – including the EPO reset.
Modifications reserved
Page 17/24
OPM_OPT_IEM_iXX_XXX_XGB_V010.doc
User Manual IEMi - Intelligent Energy Management integrated