Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 22)

iTap 10 GigaBit Port Aggregator
18
Connect the Management Port to the Network
To use the remote interfaces you must connect the Management Port on the back
of the unit to the network. You may wish to connect the Management Port on a
dedicated management VLAN for increased security.
To connect the Management Port:
1. Connect a CAT5 or CAT5e cable to the Management Port as shown in the
following figure.
Figure 9: Connecting the Management Port
2. Connect the other end of the cable to a network switch or hub.
Management
Port RS232
To network switch or hub