Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 31)

iTap 10 GigaBit Port Aggregator
27
Chapter 4
Using Web Manager
This chapter describes how to monitor and control individual iTap Port Aggregators
using Net Optics Web Manager software.
The iTap Port Aggregator has built-in support for remote control from any com-
puter with an Internet browser and access to the iTap’s IP address. Web Manager
is a browser-based interface that enables you to change settings, view status, and
retrieve data remotely. Web Manager supports all common browsers.
In this chapter, you will learn to:
• Access Web Manager
• View iTap Port Aggregator System Status from Web Manager
• View iTap Traffic Statistics from Web Manager
• Change the iTap Port Aggregator System Configuration from Web Manager
Note: ____________________________________________________________________
To access Web Manager, the Web browser must have a path to the iTap Port
Aggregator Management Port. In addition, the Management Port option in the
CLI must be set to ON. For more information, see
Configure the iTap Port
Aggregator Using the CLI
.
__________________________________________________________________________
Access Web Manager
To access Web Manager:
1. Open an Internet browser on your computer.
2. Enter the iTap’s IP address in the URL box and press Enter. The default IP
address is 192.168.1.2. The Web Manager page appears. (See the figure on the
following page.)